Readers ask: How To Size Bike Chain?

What size of bike chain do I need?

If your bike is equipped with the derailleur, you need a 3/32″ or 11/128″ chain. If you have a single-speed or internally geared bike, you need either 1/8″ or 3/32″. You should get the correct size, but if it is not possible, you can get the 1/8″ because it has limited compatibility with the 3/32″ sprocket.

How do you size a chain link?

Chain Link Sizes: How to Measure Chain Link Sizes

  1. Pitch is measured by finding the distance from the center of one pin to the center of the next pin in line.
  2. Determine your side plate height and thickness by measuring both inside and outside the roller chain to ensure that you’re seeing a good average size.

How do I know my chain size?

To measure the chain size, if you have just the sprocket, use calipers to measure between the teeth. Measure from center to center of where the chain roller would set between the teeth that will give you the pitch. Once you know the pitch you can determine what chain size you would need.

How do I know my roller chain size?

Roller Chain Identification Most roller chain has the size stamped right into the side plates. You may see something like “40”, “C2080H” or “10B” stamped in, which the industry number that represents the chain size. Old chains will most likely need to be cleaned in order to see the size.

You might be interested:  Often asked: What Size Bike Tire For Height?

How do I know if my bike chain is too short?

You should also see two slight bends at each jockey wheel of the rear derailleur. If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay. If the chain is really short, then you might not even be able to shift into the largest cog.

How do I choose a chain sprocket size?

Determine the number of teeth of the small sprocket. The number of teeth for the large sprocket is determined by multiplying the number of teeth for the small sprocket by the speed ratio. More than 15 teeth on the small sprocket is recommended. The number of teeth on the large sprocket should be less than 120.

Leave a Reply

Your email address will not be published. Required fields are marked *