FAQ: What Is The Standard Size For A Mountain Bike Shifter Cable?

What size is shifter cable?

Most brake cables are 1.5 or 1.6mm in diameter. Most shift cables are 1.1 or 1.2mm, galvanized shifter cables are 1.3mm.

Are shift cables universal?

It will work, all shift housing is interchangeable. If you need to change the cable too, make sure it has the correct end stop.

Are bike brake cables and shifter cables the same?

Just like with cables, housing comes in two different types; brake and shifter. From the outside they may look the same – but they are in fact very different. Brake housing is built around a wire that coils down the length of the cable. Shifter cables see different forces so the housing is built differently.

Does shifter cable length matter?

Sizing Housing The less drag on the cables, the better the shifting performance. Housing that is too short will kink and bind, creating even more friction. As a rule of thumb, try to size the housing so it is as short as possible but it still enters the stops and barrel adjusters in a straight approach.

You might be interested:  FAQ: What Size Hitch Pin For Yakima Bike Rack?

Can you reuse shifter cables?

You can reuse the existing cable/housing BUT the cable will “thread” through the shifter as opposed to brake levers where you can just remove the cable from the slot in the lever and leave everything in place.

Are SRAM and Shimano shifter cables the same?

Shimano designed their housing to be used with their polymer-coated cables and SRAM has a similar system. We will put a small dab of grease on the cable head as it goes into the shifter to prevent any binding at the cable head, but nothing in the housing or on the cable itself.

Can I use brake housing for shifter cables?

It’s really not recommended. Brake cable housings have a coiled metal spiral embedded in them, while compressionless shift cables have a series of tiny round wires running parallel along the length of housing. If you were to use brake cable housings on shift cables the result can be very poor shifting.

Are all Shimano gear cables compatible?

Any Shimano compatible cable will work with your shifter. I would suggest stainless steel cables (better than galvanised cables) because they will stay in nice condition, so operate well, for longer.

Is jagwire better than Shimano?

Jagwire shift housing is the same dia as Shimano etc. Their Pro brake housing is a bit thicker and a lot stiffer due to be compressionless. Shimano SP41 housing and Optislick cables are very good.

How does a gear cable work?

Cables are used to control gear shifting on bikes with geared drivetrains. They consist of two parts: an inner cable of braided stainless steel wire and an outer cable housing, and work by transmitting force using a combination of tension on the inner cable and compression to the housing.

You might be interested:  Often asked: What Size Bike Should A 5-foot 8-inch Man By?

Why is my car not shifting smoothly?

One main reason why the automatic transmission in your car may not be shifting smoothly is the ECM is going bad. It is best to get this checked out by an experienced auto mechanic technician who understands the electrical system. Other indicators include bad connections within, or worn out sensors and faulty solenoids.

Does chain length affect shifting?

Setup: Chain Length. Proper chain length makes a big difference with shifting. It’s not intuitive — that’s for sure — but lots of front shifting problems are solved by setting chain length (and tension) correctly.

What is the difference between brake and gear cable?

Brake cable housing is made from one coiled square-section wire. At the cut end you’ll only see one wire, spiralled around the housing. Gear cables (for modern STi) are made of a large no. of longitudinal wires.

Leave a Reply

Your email address will not be published. Required fields are marked *