How do I know my chain size?

To measure the chain size, if you have just the sprocket, use calipers to measure between the teeth. Measure from center to center of where the chain roller would set between the teeth that will give you the pitch. Once you know the pitch you can determine what chain size you would need.

How do I know what bike chain to buy?

How do I choose? Bike chain selection is firstly decided based upon the “speed” of the chain; this is because it determines the width of the chain. An 11 speed chain for example is narrower than a 9 speed chain, as the sprockets on the 11 speed cassette have a narrower spacing between them.

Are bike chains a standard size?

All modern bicycle chains are made to the “one-half inch pitch” standard, meaning from rivet to rivet is nominally 0.5 inches. However, this does not mean all makes and models of chains are interchangeable. There are two basic types of bicycle chains: “one-speed” chains, and derailleur chains.

How do I know my roller chain size?

Roller Chain Identification Most roller chain has the size stamped right into the side plates. You may see something like “40”, “C2080H” or “10B” stamped in, which the industry number that represents the chain size. Old chains will most likely need to be cleaned in order to see the size.

Is wd40 good for bicycle chains?

6 oz. WD-40 Specialist_® Bike Chain Lube is an all-conditions lubricant that protects bicycle chains in dry, wet, or varying conditions. The fast and easy-to-use aerosol spray helps prevent squeaks and extends the life of the chain.

How often should I change my bike chain?

The 2,000-Mile Rule. To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same.

How do you measure anchor chain link?

Anchor chain is measured in two primary ways – thickness of the metal in the link, and the length of the link. The most precise method is to use Vernier calipers, though with care a measuring tape can get a close enough estimate.

How do I know what speed my bike is?

Multiply the front gear number by the rear gear number to get the number of speeds. For example, if you have two front gears and five back gears, you have a 10-speed bike. If you have one front gear and three back gears, you have a 3-speed bike.

How do I know if my bike chain is too short?

You should also see two slight bends at each jockey wheel of the rear derailleur. If the chain is too short, this shift is difficult to make and the derailleur cage is stretched out and almost parallel to the chainstay. If the chain is really short, then you might not even be able to shift into the largest cog.